Thermal Engineer (Falcon, Dragon, & Starfall)

SpaceX was founded under the belief that a future where humanity is out exploring the stars is fundamentally more exciting than one where we are not. Today SpaceX is actively developing the technologies to make this possible, with the ultimate goal of enabling human life on Mars. THERMAL ENGINEER (FALCON, DRAGON & STARFALL) The Aero/Thermal/Fluids (ATF) group owns the thermal design of SpaceX's launch vehicles, spacecraft, and hardware for Falcon, Dragon, and Starfall. As a thermal engineer in ATF, you will take hardware from a blank page: setting the thermal architecture, sizing the design, driving it through CAD and build, and validating it against ground test, flight, and on-orbit data. You'll make the engineering calls that keep components within limits across every phase of flight - ascent, on-orbit, reentry, and improve system performance to help us fly more, and more reliably. The group's charter also spans aerothermal and vehicle fluid systems, so there's ample room to broaden into adjacent disciplines, but this role's center of gravity is clean-sheet-to-built-hardware thermal design and analysis. RESPONSIBILITIES: Own the thermal design of spacecraft, launch-vehicle, special-program, and component hardware end-to-end: from initial concept and high-level trades, through detailed 3D and reduced-order modeling, into CAD/build, and out to validation against ground test, flight, and orbital data (e.g. on-orbit thermal analysis, thermal protection system (TPS) sizing, heater and coolant-loop design, acceptance/qualification test-level derivation, issue-ticket resolution) Translate thermal analysis into real design decisions — materials, coatings, insulation, interfaces, heater and TCS architecture — and carry them from concept to flight hardware Automate your workflow to cut engineering investment in the design cycle Pursue performance and robustness improvements in the hardware Pursue operational simplicity and reduce the burden your designs place on other group